For greenhouse growers

Buying grow lights?
Start here.

Watch a short video. Get the free checklist. Then send us your list.

Link4 Pearl controller
Pearl controllerRuns your lamps.
Link4 lighting panel with the door open
Lighting panelSwitches them.
Link4 PAR light sensor
PAR sensorCounts the light.

The video

Grow lights, explained

About four minutes. Light, sensors, lamps, wiring, and how Link4 runs them.

Light check

Do you need grow lights?

Pick your region, crop, month and roof. See how much sun reaches your plants.

Pick your region to see your light.

Estimates only. These figures use long term average sunlight for one spot in each region and a typical light loss for each roof type. Your weather, roof age and cleanliness, shade and crop will differ, and a cloudy week can fall well short of the average. This is a rough guide, not a lighting design and not a promise of crop results. Check with Link4 or your lighting supplier before you buy. Link4 Corporation accepts no liability for decisions made from these estimates. Crop targets are typical figures from greenhouse extension guidance; growers set their own. Sunlight data: NASA Langley Research Center POWER Project, funded through the NASA Earth Science Applied Science Program.

The Link4 grow light checklist, one page

The checklist

One page. Two short lists.

  • What to ask before you buy lights.
  • What to send your control company.
  • A box for your dealer's name.

Lighting panels

GEN 13 and GEN 14 lighting panels

Link4 lighting panels hold the contactors that switch your lamps on and off.

SpecGEN 13GEN 14
Contactors48
Cooling fanNoBuilt in
Size, inches16 x 14 x 824 x 16 x 8
Weight38 lb55 lb
Item code970-3001-04970-3001-03

Both panels:

  • UL 508A listed, and cUL listed for Canada.
  • NEMA 4 enclosure.
  • A time delay between contactors, to cut the surge when lamps switch on.
  • A heat sensor that shuts the panel down if it gets too hot.
  • An Auto, On, Off switch, and a big light that shows the lamps are on.
  • Daisy chain more panels as you add lamps.
  • Works with LED, HPS, ceramic metal halide and fluorescent lamps.
The Link4 GEN 13 and GEN 14 lighting panel spec sheet

Your next step

Send Link4 your lighting list.

We will tell you how we would control your lights. We will name the sensors you need. We will say what goes in the lighting panel.

  1. You send your list.
  2. We plan the controls.
  3. Your lamps fill the gap the sun leaves.

Or call (866) 755-5465. Or ask your Link4 dealer.

Have a light plan or spec sheets? Say so above, and we will ask for them.

How Link4 runs them

Four ways the Pearl runs your lamps

On a scheduleOn and off at set times.
Fill in for the sunOn when it gets dark outside.
A daily light targetOff once the plants have had enough.
Your own rulesLike lamps off when power costs most.

We make growing easier.

0